Marantz M-CR610 appendix 22Cannot connect by Wi-Fi

ContentsConnectionsPlaybackSettingsTipsAppendix

22Cannot connect by Wi-Fi

Symptom	Cause/Solution	Page
Cannot connect to the network.	• The network name and password (WEP, etc.) settings are wrong. Configure the network	89
	settings according to the setting details of this unit.	–
	• Reduce the distance between the wireless LAN access point and this unit, remove any
	obstructions and make sure the view to the access point is unobstructed before trying to
	connect again. Also, install microwave ovens and other network access points as far away
	as possible.	–
	• Check the router power supply.
	• This unit is compatible with IEEE 802.11b/g.	–
	• Configure the access point channel settings away from channels that are being used by other	–
	networks.	–
	• This unit is not compatible with WEP (TSN).
Cannot connect to WPS.	• Check that the WPS mode of the router is operating.	–
	• Within 2 minutes, press and hold the Wi-Fi Connect button on the unit for three seconds.	–
	• A router/settings that are compatible with WPS 2.0 standards are required. Set the encryption	87
	time to “None”, “WPA-PSK (AES)” or “WPA2-PSK (AES)”.	88, 89
	• If the router encryption method is WEP/WPA-TKIP/WPA2-TKIP, you cannot connect by
	using the Wi-Fi CONNECT button. In this case, use the “Auto-Scan” or “Manual” method
	to connect.
Cannot connect to the network using	• Update the iPhone/iPod touch/iPad firmware to the latest version.	–
iPhone/iPod touch/iPad

			102
Front panel	Rear panel	Remote		Index