Marantz M-CR610 appendix Clock Speaker Configuration, 22Set the current time, 22Bi-Amp, 22Response

ContentsConnectionsPlaybackSettingsTipsAppendix

Clock			Speaker Configuration
22Set the current time			You can set up the Bi-Amp function, speakers to use, and the properties
			of speakers.
	You can automatically adjust the clock of this unit using the Internet.		22Bi-Amp
	%
					You can use the Speakers A/B terminals to output audio from speakers
	• To use this function, the unit must be connected to the Internet.				compatible with Bi-Amp drive.
1 Use ui to select your time zone, then press ENTER.
					Enable : The Bi-Amp function is enabled.
					Disable (Default) : The Bi-Amp function is disabled. You can switch
2
		Use ui to select the DST (Daylight Saving Time), then			between Speakers A and B.
		press ENTER.	22Response

On : Set the DST (Daylight Saving Time) to on.		Set the output frequency characteristics.
Off	(Default) : Set the DST (Daylight Saving Time) to off.
		Flat (Default) : Properties are flat.
		Response 1 : Cuts low frequencies 60 Hz or under by –12 dB/oct.
		Response 2 : Cuts low frequencies 100 Hz or under by –12 dB/oct.
		Response 3 : Cuts low frequencies 60 Hz or under by –12 dB/oct.
		Also, raises the 400 Hz region by 3 dB.
		Response 4 : Cuts low frequencies 100 Hz or under by –12 dB/oct.
		Also, raises the 400 Hz region by 3 dB.

%

• “Response” setting values are not reflected in headphone out, Audio out or subwoofer out.

			82
Front panel	Rear panel	Remote		Index