13
ENGLISH
SETTING THE GROUP ID SELECTOR
The RC3001 can use the Wizz.it 3 editor to set the group ID for each device.
If a different ID signal is sent from the remote controller, no control signal is output from the RX3001.
Normally, set to ID1 when not using the group ID function.
Receiver side
Group ID Emitter Output
1
1 Set ID 1
2 Set ID 1
3 Set ID 1
4 Set ID 1
5 Set ID 1
6 Set ID 1
Receiver side
Group ID Emitter Output
2
1 Set ID 1
2 Set ID 1
3 Set ID 1
4 Set ID 2
5 Set ID 2
6 Set ID 2
Output from the Output jack is controlled as shown below based on the remote device ID setting and
receiver ID setting.
Remote device ID Receiver
GROUP ID GROUP ID SW Emitter Output OUTPUT signal
11
1 OUTPUT
2 OUTPUT
3 OUTPUT
4 OUTPUT
5 OUTPUT
6 OUTPUT
GROUP ID GROUP ID SW Emitter Output OUTPUT signal
21
1 NO-OUT
2 NO-OUT
3 NO-OUT
4 NO-OUT
5 NO-OUT
6 NO-OUT
GROUP ID GROUP ID SW Emitter Output OUTPUT signal
22
1 NO-OUT
2 NO-OUT
3 NO-OUT
4 OUTPUT
5 OUTPUT
6 OUTPUT
GROUP ID GROUP ID SW Emitter Output OUTPUT signal
12
1 OUTPUT
2 OUTPUT
3 OUTPUT
4 NO-OUT
5 NO-OUT
6 NO-OUT
12ID