ENGLISH | 4. This screen changes to HOME mode. | |||
Press the button next to the displayed | ||||
| ||||
| device name whose commands you want | |||
| to learn. | |||
|
|
|
| |
|
|
|
| |
Note:
In Home mode, learning cannot be performed with the SOFT button using the procedure shown below. Use the Wizz.it 3 editor to make any changes.
5. After selecting the device name, press the button whose command you want to learn.
6. This enters the learning standby mode. Send the remote controller code that you want to learn.
7. The remote controller has completed learning when “LEARN OK” is displayed on the LCD.
•Pressing the ENTER button enables you to continue learning commands for another button in the same device mode.
•When the learning mode is completed, press the Home button three times to return the LCD to the MAIN MENU.
Notes:
•If learning could not be performed, “LEARN ERROR” is displayed on the LCD. Try performing steps 5 to 6 again.
•When making the learning settings, the “LEARN ERROR” message may occasionally be displayed repeatedly on the LCD. In some cases, this can be due to transmission of a special remote controller signal code. Learning cannot be performed when a special remote controller signal code is used.
•The RC3001 can learn up to a maximum of 1,000 remote controller codes. Once 1,000 codes are programmed for learning, “LEARNFULL” is displayed on the LCD, and learning can no longer be performed.
To perform further learning, use the Wizz.it 3 editor to delete any unneeded learning codes.
16
