Marantz SR-14EX manual Rear Panel Connections

ENGLISH

REAR PANEL CONNECTIONS

All connections to the rear panel should be made with the entire system powered off.

To avoid errors, it is advisable to connect one cable at a time between the various components.

		11
21	10	16	17	18	14	1	2	13	22

COAX

OUT

OPT

OUT

DIG .1

IN

DIG .2

IN

DIG .3

IN

DIG .4

IN

FRONT		SURROUND			(FRONT)
L	R	L	R		L	R
L	R	L	R		L	R	SUB
FRONT		SURROUND		CENTER	SURROUND BACK WOOFER
		S - VIDEO
TV	LD	DVD	VCR1	VCR1	DSS / VCR2 DSS / VCR2		MONI.
S2 IN	S2 IN	S2 IN	S2 IN	OUT	S2 IN	OUT	S2 OUT
		VIDEO					MONI.

				R	FRONT	L
FM (75Ω )		GND	AM
MAIN
IN
			ANTENNA
PRE				R	SURROUND	L	CENTER
OUT
COMPONENT VIDEO
Y	Cr	Y	Cr
VCR1			DVD
IN			IN
MONITOR			DSS	S PEAKER	SYSTEMS	8 OHMS
			/ VCR2
OUT			IN
					AC OUTLETS		AC INLET

	DIRECT IN		120V 60HZ
			SWITCHED 120W 1A
	SUB
MULTI	CENTER WOOFER	SURROUND
ROOM
			UNSWITCHED 120W 1A
		L	R

DIG .5 IN

DIG .6

/

RF IN

L					IN
					OUT
R
TV	LD	DVD IN – VCR1 – OUT IN – DSS/VCR2 – OUT	AUDIO	CD IN – TAPE – OUT	IN – CD-R / MD – OUT REMOTE MULTI
		AUDIO	MULTI	AUDIO	REMOTE CONTROL
			ROOM

19	20	9	5	6	12	3
			8		15

1 FM antenna terminal (75 ohms)

Connect an external FM antenna with a coaxial cable, or a cable network FM source.

2 AM antenna and ground terminals

Connect the supplied AM loop antenna. Use the terminals marked “AM” and “GND”. The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best

3 Three analog audio inputs

CD, TAPE, and CD-R/MD :

Connect the audio outputs of your source components to the input jacks on the receiver.

4Two analog audio outputs for audio source equipment

TAPE and CD-R/MD :

Connect each output to the audio inputs (REC in) of your recording equipment.

5Five analog audio inputs for video source equipment

TV,LD,DVD, VCR1, and DSS/VCR2 :

Connect each input to the audio outputs of your video source equipment.

6Two analog audio outputs for video source equipment

VCR1, and DSS/VCR2 :

Connect each output to the audio inputs (REC in) of your video recording equipment.

4 23 24 7 25 26

7 6-Channel Inputs

If an external digital audio decoder is used, connect the outputs of that decoder to these jacks. Note that front L&R channels are common used in analog audio inputs, use the assigned input in OSD setup menu system.

(See page 18 “System setup 1/2”.)

8 Five video inputs

TV,LD,DVD, VCR1, and DSS/VCR2 :

Connect each input to the video outputs of your video source equipment.

9 Two video outputs

VCR1, and DSS/VCR2 :

Connect each output to the video input (REC in) of your video recording equipment.

10 Five S-video inputs

TV,LD,DVD, VCR1,and DSS/VCR2 :

Connect each input to the S-video outputs of your video source equipment.

11 Two S-video outputs

VCR1, and DSS/VCR2 :

Connect each output terminals to S-video input (REC in) of your video recording equipment.

12 Monitor. (VIDEO/S-VIDEO) output jacks

Connect this jack to the composite or S-Video input of a TV monitor or video projector to view the on-screen menus and the output of any standard video source selected by the receiver’s video switcher.

10