Inserting the batteries

q Remove the rear lid in the

w Load the two batteries properly

direction of the arrow and

as indicated by the marks in

remove it.

the battery compartment.

 

Batteries

ePut the rear cover back on.

NOTE

•Insert the specified batteries in the remote control.

•Replace the batteries with new ones if the set does not operate even when the remote control is operated close to the unit. (The supplied batteries are only for verifying operation.)

•When inserting the batteries, be sure to do so in the proper direction, following the q and w marks in the battery compartment.

•To prevent damage or leakage of battery fluid:

•Do not use a new battery together with an old one.

•Do not use two different types of batteries.

•Do not attempt to charge dry batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in flames.

•Do not keep the battery in a place exposed to direct sunlight or in places with extremely high temperatures, such as near a heater.

•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

•Remove the batteries from the remote control if it will not be in use for long periods.

•Used batteries should be disposed of in accordance with the local regulations regarding battery disposal.

Remote control unitOperating range of the remote control

Point the remote control at the remote sensor when operating it.

Approx. 23 ft/7 m

30° 30°

NOTE

•The set may function improperly or the remote control may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.

•When using 3D video devices that transmit radio communication signals (such as infrared signals etc.) between the various units (such as the monitor, 3D glasses, 3D transmitter unit etc.), the remote control unit may not operate due to interference from those radio communication signals. If this occurs, adjust the direction and distance of the 3D communication for each unit, and check that the remote control unit operation is not affected by these signals.

version Basic

version Advanced

Information

DVD

48