ENGLISH
The Screen Images in a 4:3 screen
•Press the ZOOM button, the NORMAL button or the FULL button on the remote controller for the 4:3 aspect ratio video source.
•Press the FULL button on the remote controller for 16:9 aspect ratio video source, such as 1080i, 1035i, and 720p video systems.
•Press the FULL button on the remote controller for the squeezed video source.
❖V-Stretch mode
The 2.35:1 image is shown across the entire screen.
❖Original Source Image
16 : 9 video source
❖Full mode
The 16:9 squeezed image is displayed with the
4 : 3 video source
The 4:3 image is enlarged horizontally.
❖Through mode
Images are shown at the same resolution as RGB/video signals.
correct aspect.
❖Normal mode
To Turn off the Power
1.Press the STANDBY button on the remote controller or the 
/ I button on the projector.
2.The fan continues running for about 1 minute to internally cool the projector. In the meantime, the ON indicator on the projector flashes a blue color and buttons on the projector and remote control are irresponsive to touch. Once the fan stops, the ON indicator goes out and the STANDBY indicator lights up a green color to indicate the projector is on standby.
The picture in normal ratio 4:3 is displayed.
❖Zoom mode
The picture in normal ratio 4:3 is enlarged vertically and horizontally (with same ratio) to the screen size
STANDBY | ON |
IRIS LAMP C.TEMP GAMMA
COMP.1 COMP.2
C1 C2 S G1
HDMI 1 HDMI 2 | VIDEO |
H1 H2 V G2
AUX 1 | AUX 2 |
A1 A2 RGB G3
Notes :
-Do not pull out the AC power cord until the projector turns in standby mode.
-Do not pull out the power cord suddenly in the state of “POWER ON." It can cause a breakdown.
-If the WARNING indicator lights up or blinks a yellow color, check that the fan has stopped then unplug the AC power cord from its outlet.
-The projector will not be turned on if the ON button on the remote controller or the 
/ I button on the projector is pressed immediately after turning off. Press the ON button on the remote controller
or 
/ I button on the projector after the projector turns into standby mode.
-When on standby, power to the projector is not OFF completely. If not planning to use the projector for an extended period of time, unplug the AC power cord from AC power outlet as explained above.
18
