Mark Levinson N 326S Display Intensity

4-2
Controls & Modes Mark Levinson
When the –OFF– setting is selected, the Nº326S does not
automatically enter standby. When a time increment setting is
selected, the Nº326S automatically enters standby after the
designated amount of time has passed. For example, if the 2h
30m setting is selected, the Nº326S automatically enters standby
after 2 hours and 30 minutes have passed.
To set the sleep timer:
1. Follow the instructions on the previous page to take the
Nº326S out of standby.
2. Press and hold the front panel or remote control standby
button until the SLEEP parameter opens on the front panel
display as shown to the left.
3. Press and release the standby button to cycle through all
available SLEEP parameter settings.
4. When the desired setting is selected, press the front panel or
remote control enter button to close the SLEEP parameter.
•Otherwise, the SLEEP parameter automatically closes a
few seconds after the last command is received. If this
occurs, the selected setting is automatically applied.
Note
The SLEEP parameter is set to –OFF– whenever the Nº326S
is placed into standby.
Display Intensity
Controls the illumination of front panel display characters and
the front panel standby LED. Four illumination levels are available,
including FULL (100%), HALF (50%), DIM (25%), and OFF (0%).
The factory-default illumination level is FULL (100%).
When the OFF (0%) illumination level is selected:
•The front panel display automatically activates whenever a
change in status is detected.
•The front panel standby LED lights at the FULL (100%)
illumination level.
SLEEP –OFF–