DVD or SAT).
4.Enter the 3 digit code from the library code table (separate booklet). The LED turns off after the last digit entered.
5.Point the remote at the device and press the POWER button. Your device should turn off.
6.Turn your device on and press CHAN+. If the device responds, setup is complete.
Notes:
The TV key can only be used to store TV codes, but you can store a code for ANY device under either the VCR, SAT or DVD key. E.G. program your first SAT receiver under the SAT key, and your second SAT receiver under the DVD key.
If your TV, VCR or Satellite receiver does not respond, try the other codes for your brand. If it still does not respond, try the "Code Search" method (8.5).
If the LED blinked rapidly when you entered the code, you may have entered an invalid code. Recheck the code in the code list and try again.
7.4. Manual code search:
When you cannot find your device in the code list or your device does not respond after you entered the codes for your brand, you can try to find the right code by using the manual code search:
1.Turn on the device you want to control.
2.Press and hold SETUP until the LED indicator lights steadily. Release the SETUP button.
3.Press the mode button (TV, VCR, etc.) that matches the equipment you want to control. The LED blinks once.
4.Press CHAN+ repeatedly until the device to be controlled changes channel. If you accidentally go past the code press CHAN – repeatedly until the channel changes again.
5.Press and release the ENTER button to complete the setup.
Note: When searching for a code you might have to press CHAN + many times (50+). If the device does not have a Channel Up function, use the PLAY button (VCR only) or the POWER button.
7.5. Automatic code search
The remote is able to browse through the codes in it’s library automatically. When your device responds, you can stop the search function and store the code.
1.Turn on the device you want to control
2.Press and hold SETUP until the LED indicator lights steadily. Release the SETUP button.
3.Press the mode button that matches the equipment you want to control. The LED blinks once.
4.Press CHAN+ ONCE. After few seconds the remote will start a automatic search through its
12 | MARMITEK |
