respond to the setting of the physical Appliance Module that you will install (sold sepa- rately).
Make sure the Address Dials on the face of the Modules are set correctly. The red dial should be set to A on both Modules. The black dial on the Lamp Module should be set to 1 and the black dial on the Appliance Module should be set to a 2. If they are not set correctly, you can reset the dials with a small
LAMP MODULE LM12 (sold separately)
To control a lamp using AHP, follow these steps.
Please read through these installation steps completely before you start to install a Lamp Module.
1.Select a nearby lamp, one that uses a standard light bulb, and make sure its on/off switch is switched on.
2.Unplug the lamp from the wall outlet and plug it into the Lamp Module.
3.Plug the Lamp Module into a nearby AC outlet. If this outlet is controlled by a wall switch, make sure the wall switch is turned on.
4.If you have not already done so, start your AHP software by double clicking on the AHP icon.
5.Using your mouse, click the switch of "My Lamp Module" as shown on your com- puter screen. There may be a delay of one or two seconds from the time you click the "on screen" module switch and when the light actually turns on. You can also dim the lamp by moving the slide switch up and down.
APPLIANCE MODULE AM12 (sold separately)
Controlling an appliance is just as easy!
Please read through these installation steps completely before you start to install an Appliance Module.
1.Select a small appliance, such as an AC powered radio, and make sure its on/off switch is switched on.
2.Unplug the appliance from the wall outlet and plug it into the Appliance Module.
3.Plug the Appliance Module into a nearby AC outlet. If this outlet is controlled by a wall switch, make sure the wall switch is turned on.
4.If your AHP software is not running, start it by double clicking on the AHP icon.
5.Using your mouse, click the switch of "My Appliance" as shown on your computer screen. There may be a delay of one or two seconds from the time you click the "on screen" module switch and when the appliance actually turns on.
Timers
You can schedule each of your Modules to turn on or off any time by clicking on the small clock at bottom left hand side of your "on screen" modules. If you have trouble
8 | © MARMITEK |
