MartinLogan MAC 500/E C 5 0 0 E w i t h e l e c t r o n i c b a l l a s t, R m a l u p l o a d

M A C 5 0 0 E w i t h e l e c t r o n i c b a l l a s t

Electronic ballast models that come factory set for 100 V or 120 V have a 10 A main fuse, which is located near the power switch. Units set at 210 V and above have a 6.3 A main fuse. Use a 6.3 A fuse when the WUDQVIRUPHU is set at

200, 210, 220, 230, or 240 V. Use a 10 A time-delay fuse when it is set at 100, 110, or 120 V.

No rewiring of the electronic EDOODVW is necessary; it works at any voltage between 100 and 250 volts, and at any fre- quency between 50 and 60 Hz. The WUDQVIRUPHU must be tapped for the local supply voltage as shown below.

	black						black						black
	6	7	8		9		6	7	8	9			6	7	8	9
	5						5				brown		5
											red
blue	4	100 V			brown		4	110 V					4	120 V
					red
brown	3					blue	3					blue	3
red
blue	1				blue		1				blue		1
blue					blue						blue
brown						brown						brown
red						red						red
	7		8	9				7	8	9				7	8	9
	6				black		6				black		6
black	5						5						5
	4	210 V					4	220 V					4	230 V
	3						3						3
blue	1				blue		1				blue		1
blue					blue						blue
									MAC 500 E Transformer Settings
U p d a t i n g s o f t w a r e

brown red

			6		7		8	9
	black	5				200 V
			4
blue				3
			1
blue

brown red

7 8 9

	black	6
		5
			240 V
		4
blue		3
		1
blue

The latest software for the MAC 500/E is available from your Martin dealer and the Martin Professional web site. Please read the update notes bundled with the software. Update software is uploaded to the MAC 500/E using a Martin uploader such as the MBPP1, or MP-2.

N o r m a l u p l o a d

Connect the uploader to the fixture just like a controller. Under normal conditions, software can be installed from a remote location - there is no need to set the MAC 500/E to boot mode. Please refer to the uploader manual for further instructions.

B o o t m o d e u p l o a d

If the data is corrupted during transmission, a check-sum error (CSER) will occur and after 15 seconds the fixture will automatically switch to boot mode (UPLd) and be ready for a boot-mode upload as described below and in the uploader manual.

If a software upload to the MAC 500/E is interrupted, the fixture must be powered off for at least 10 seconds before a new upload can be attempted. When powered on, a check-sum error will occur and it will automatically go into boot mode, ready for a second upload attempt. Select boot mode upload on the uploader.

Maintenance and Basic Service 23