Manuals / MasterCraft / Marine Equipment / Boat

MasterCraft 2009 MariStar X-Series owner manual Inspect the Propeller Shaft Log for Water Entry

Models: 2009 MariStar X-Series

1 88
Download 88 pages 62.86 Kb
Page 57
Image 57

the box with the water-and-baking-soda solution as is used in cleaning the terminals. Rinse with fresh water and dry with a cloth.

•Reconnect the positive terminal first, then the negative. Tighten the terminals. Coat both terminals completely with a thin covering of marine grease. Be sure that the rubber boot covers the positive terminal completely.

Note: The boat’s engine is designed to work with the standard electronics installed in the boat. Adding other electrical com- ponents or accessories can change the way the fuel injection controls the engine or the overall electrical system functions. Before adding electrical equipment, consult an authorized MasterCraft dealer’s service department. Otherwise, the en- gine may not perform properly.

Add-on equipment may adversely affect the alternator output or

 

overload the electrical system. Such damage may not be covered

Step 1: Ensure the engine is OFF and the engine safety starting

by the warranty.

switch disconnected. Be certain that the throttle/shift

If a replacement battery is required, be certain to select a marine

control lever is in neutral.

 

battery with at least seven-hundred-fifty (750) cold-cranking-

Step 2: Open the engine compartment and locate the throttle

amps at zero degrees (0o) Fahrenheit. Before disconnecting the

and shift cables. Follow each cable back under the

battery, make sure the ignition key and all accessories are in

floorboards and feel for any kinks and wear on the

the OFF position. Also remember to re-attach the cables in the

outer jacket. Any sign of cable damage is cause for

proper order, with the negative cable connected to the negative

replacement. See your authorized MasterCraft dealer’s

[-] post and the positive cable connected to the positive [+] post.

service department.

When charging, batteries generate small amounts of danger- ous hydrogen gas. This gas is highly explosive. Keep all sparks, flames and smoking well away from the area. Failure to follow instructions when charging a battery may cause an electrical charge or even an explosion of the battery, which could result in death or serious injury.

MasterCraft recommends the use of a spiral-cell type battery, such as the Optima brand. These batteries exceed other batteries in holding and extending a charge.

Inspect the Throttle and Shift Cables for

Kinks, Wear and Interference (RTP-1 and Twin

MCX Installations Only)

Some engine parts become very hot during operation. This inspection must be completed while the engine is cool to prevent burns to your skin. Perform this task before starting the boat.

Inspect the Propeller Shaft Log for Water Entry

After approximately three (3)-to-five (5) minutes of boat operation in the water, shut off the engine and open the engine compartment. Be careful to avoid burns from contact with hot engine parts. The boat is equipped with a dripless shaft log and if it is showing any signs of dripping, the boat must be taken to an authorized Master- Craft dealer’s service department for correction.

MasterCraft 2009 Owner’s Manual - Page 16-2

Page 56 Page 58
Page 57
Image 57
MasterCraft 2009 MariStar X-Series owner manual Inspect the Propeller Shaft Log for Water Entry, By the warranty
Page 56 Page 58

2009 MariStar X-Series specifications

The 2009 MasterCraft MariStar X-Series stands out as a remarkable blend of luxury and performance in the world of wakeboarding and recreational boating. Designed for enthusiasts who demand the best, this model encapsulates everything that differentiates MasterCraft's prestigious line of boats.

The MariStar X-Series boasts a sleek, aerodynamic hull that not only enhances its visual appeal but also contributes to its superior handling and smooth ride. With a length of 22 feet, it provides plenty of space for friends and family while maintaining the agility required for wake sports. The deep-V hull design effectively cuts through choppy waters, creating a stable and comfortable experience for passengers.

One of the standout features of the MariStar X-Series is its powerful engine options. The boat offers a range of high-performance engines, allowing users to select the power that best suits their needs. With options that can deliver up to 350 horsepower, the MariStar ensures exhilarating speed and excellent torque for wakeboarding, wake surfing, and other water activities.

The boat’s unique ballast system is designed to enhance the quality of the wakes produced, allowing for optimal wakeboarding conditions. The integrated system lets users easily fill and drain water ballast to customize the wake shape and size, ensuring that every rider gets the best possible experience.

Inside, the cabin of the 2009 MariStar X-Series is a testament to luxury and convenience. Plush seating provides comfort, while the premium sound system delivers high-quality audio perfect for a day out on the water. The cockpit is laid out for easy access to controls, making it user-friendly for both seasoned drivers and novices.

Additional features include a foldable bimini top that provides shade during sunny outings and ample storage compartments for gear. The attention to detail extends to the materials used in the upholstery, which are not only stylish but also durable and easy to maintain.

Overall, the 2009 MasterCraft MariStar X-Series combines performance, technology, and luxury in a single package. Its innovative design and features cater to both recreational users and serious water sports enthusiasts, making it a cherished choice for those looking to elevate their on-water experience.