Matsui America M22LID618 manual Initial Settings, General Operation, Information Banner

Initial Settings

When the TV set is operated for the first time, the IDTV turns on first.

Because this is the first time the TV is used, there are no channels stored in the memory and the following message appears on the screen:

Please ensure aerial is plugged in. Do you want to start first time installation?

Yes No

•To start installation process, select “Yes”, to cancel select “No”.

•To select the “Yes” or “No” option, highlight the item by using or buttons and press the OK button.

The IDTV will automatically tune to the UHF transmision channels 21 to 68, searching for digital terrestrial TV broadcasts and displaying the names of channels found. This process will take about five minutes. To cancel searching, you can press the M button at any time during the process.

AUTOMATIC SEARCH

Channels:

BBC ONE

BBC TWO

BBC CHOICE

Searching UHF channels 30. Please wait. This will take a few minutes

12 %

MEN U Cancel search

After Automatic Search is completed, the following message asking for analogue channel search appears on the screen:

Do you want to search for analogue channels?

Yes No

To seach for analogue channels, select “Yes”. TV switches to the analogue TV mode. The menu below is displayed to search for analogue channels:

Auto. Programming System
Language	English
Country	U.K.
Txt. Region	West Europe
Check the antenna cable
Start : Ok	Exit : TV

Set Language item by pressing  or  button. Press  or  button to highlight Country item and then use  or  to set. Press  or  button to highlight Txt. Region. Select a region by using  or  button. When finished, press OK button to continue. To cancel, press the

TV button.

For more information on this process, see “Install Menu” section.

NOTE: For proper functioning of digital teletext in DTV mode, you should set country as UK in analogue APS.

General Operation

Pressing the TV or DTV button at any time while watching television programmes will switch the TV set between displaying the digital terrestrial television broadcasting and its normal analogue broadcasting.

Information Banner

•Whenever you change channel, using the P- / P+ button or the numeric buttons, the TV displays the broadcast picture along with an information banner at the bottom of the screen. This will remain on the screen for approximately three seconds.

•The information banner can also be displayed at any time while watching TV by

pressing the button on the remote control:

- 19 -

00-ENG-01-TV-2297W-UK IDTV-1165UK-VGA-1910057841.p65 25.06.2008, 09:06