Extended AT Commands Manual Page 37 of 70 2009-06-25
0 No CBM indications are routed to the TE.
1 If CBM is stored into ME/TA, indication of the memory location is routed to the
TE using unsolicited result code:
+CBMI: <mem>,<index>
2 New CBMs are routed directly to the TE using unsolicited result code:
+CBM: <length><CR><LF><pdu> (PDU mode enabled); or
+CBM: <sn>,<mid>,<dcs>,<page>,<pages><CR><LF><data> (text mode
enabled)
If ME supports data coding groups which define special routing also for messages other
than class 3 (e.g. (U)SIM specific messages), ME may choose not to route messages of
such data coding schemes into TE (indication of a stored CBM may be given as defined
in <bm>=1).
3 Class 3 CBMs are routed directly to TE using unsolicited result
codes defined in <bm>=2. If CBM storage is supported, messages of other
classes result in indication as defined in <bm>=1
<ds>
0 No SMS-STATUS-REPORTs are routed to the TE.
1 SMS-STATUS-REPORTs are routed to the TE using unsolicited result code:
+CDS: <length><CR><LF><pdu> (PDU mode enabled); or
+CDS: <fo>,<mr>,[<ra>],[<tora>],<scts>,<dt>,<st> (text mode
enabled)
2 If SMS-STATUS-REPORT is stored into ME/TA, indication of the memory
location is routed to the TE using unsolicited result code:
+CDSI: <mem>,<index>
<bfr>
0 TA buffer of unsolicited result codes defined within this command is flushed to
the TE when <mode> 1...3 is entered (OK response shall be given before flushing the
codes).
1 TA buffer of unsolicited result codes defined within this command is cleared
when <mode> 1...3 is entered.
Execution command returns messages with status value <stat> from message storage <mem1> to
the TE. About text mode parameters in italics, refer command Show Text Mode Parameters +CSDH.
If status of the message is 'received unread', status in the storage changes to 'received read'. If
listing fails, final result code +CMS ERROR: <err> is returned. See chapter Message Service
Failure Result Code for <err> values.