![](/images/new-backgrounds/1118461/118461111x1.webp)
12.2. Basic AT Commands
The following table specifies the basic AT parameters to be supported for the data service. Exceptions to
12.2.1. Basic AT Parameters
Table 12.78 Basic AT parameters
| Parameter |
|
| Description |
| Packet | STU- | |
|
|
|
| Data |
| III | ||
|
|
|
|
|
|
| ||
| E0 |
|
| Do not echo command set in command state or online | O |
| N/A | |
|
|
|
| command state. |
|
|
|
|
| E1 |
|
| Echo command set in command state or online command | O |
| N/A | |
|
|
|
| state. |
|
|
|
|
| L0 |
| Low speaker volume. |
| N/A |
| N/A | |
| L1 |
| Low speaker volume. |
| N/A |
| N/A | |
| L2 |
|
| Med speaker volume. |
| N/A |
| N/A |
| L3 |
|
| High speaker volume. |
| N/A |
| N/A |
| M0 |
| Speaker off. |
| N/A |
| N/A | |
| M1 |
|
| Speaker on until carrier reported (support of this feature is | N/A |
| N/A | |
|
|
|
| optional). |
|
|
|
|
| Q0 |
| Return result codes. |
| R |
| R | |
| Q1 |
|
| Do not return result codes. | R |
| N/A | |
| V0 |
| Display result codes as numbers. | R |
| R | ||
| V1 |
| Display result codes as words. | R |
| R | ||
| X1 |
|
| Enable additional result code CONNECT <rate>. Disable dial | N/A |
| N/A | |
|
|
|
| tone and busy detection.1 |
|
|
|
|
| X2 |
|
| Enable additional result codes CONNECT <rate> and NO | N/A |
| N/A | |
|
|
| DIALTONE. Disable busy detection. Enable dial tone |
| ||||
|
|
|
| detection.1 |
|
|
|
|
| X3 |
|
| Enable additional result codes CONNECT <rate> and BUSY. | N/A |
| N/A | |
|
|
|
| Enable busy detection. Disable dial tone detection.1 |
|
|
| |
| X4 |
|
| Enable additional result codes CONNECT <rate>, BUSY | N/A |
| N/A | |
|
|
|
| and NO DIALTONE. Enable busy and dial tone detection.1 |
|
|
| |
|
|
|
| Reset to default user configuration. |
|
|
| |
| Z0 |
|
| Note: ATZ with firmware R2.1.3 clears the +CSCA | R |
| N/A | |
|
|
|
| settings. You have to enter the +CSCA values again to be |
|
|
| |
|
|
|
| able to send SMS messages. |
|
|
| |
| &C0 |
|
| Circuit 109 (CF) always ON. | R |
| N/A | |
| Extended AT Commands Manual | Page 56 of 70 |
|