Paradyne 4200 manual Rept-Opstat-Ipport, 8-14, 11. REPT-OPSTAT-IPPORT Command Parameters, IP c

8. IP Access Commands

REPT-OPSTAT-IPPORT

The command REPT-OPSTAT-IPPORT reports current operational parameters for an Internet Protocol port (or interface) in the NE.

Table 8-11. REPT-OPSTAT-IPPORT Command Parameters

REPT-OPSTAT-IPPORT:[tid]:aid_ipport:[ctag][:];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_ipport	Access identifier of the IP port to be entered. The value can be
	preceded with AID=, but this is not required. The valid values are:
	ATM-1: First IP-over-ATM interface in the NT
	ATM-2: Second IP-over-ATM interface in the NT
	ETH-1: First Ethernet interface in the NT
	Grouping and ALL are allowed.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* REPT-OPSTAT-IPPORT:[tid]:aid_ipport:[ctag][:] */

"aid_ipport:op_ipport,value"

;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY;

/* REPT-OPSTAT-IPPORT:[tid]:aid_ipport:[ctag][:] */ "aid_ipport:ERRCDE=errcde

/* error description */

;

8-14 August 2002 4200-A2-GB20-00