Paradyne 4200 manual 10-12, 7. RTRV-ALM-T1 Command Parameters

10. Fault Commands

RTRV-ALM-T1

The RTRV-ALM-T1 command retrieves current alarms for selected DS1 facilities.

Table 10-7. RTRV-ALM-T1 Command Parameters

RTRV-ALM-T1:[tid]:aid_ds1:[ctag]::[ntfcde],,[srveff],[locn] ,[dirn];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	The identification of the target NE. TID is optional and has a default
	value of null. The NE's SID code is the only other valid value.
aid_ds1	Access Identifier for the DS1 facility. Enter in the following format,
	replacing lower-case parameters with the values given:
	NTT: circuit
	circuit: DS1 circuit on the NT (1− 4)
[ctag]	The correlation tag that correlates an input command with its associated
	output response(s). It is assigned by the originator of the command. The
	value is limited to six characters, which may be an identifier or a decimal
	numeral. It is optional with a default of 0.
[ntfncde]	Notification code. Valid values are:
	CR: Critical alarm
	MJ: Major alarm
	MN: Minor alarm
	Grouping is allowed. If no value is specified, ALL is assumed.
[serveff]	Service effect. Valid values are:
	SA: Service affecting
	NSA: Not service affecting
	Grouping is allowed. If no value is specified, ALL is assumed.
[locn]	Location of the condition. Valid value is NEND (Near End).
[dirn]	Direction of the condition. Valid value is RCV (Receive).

10-12 August 2002 4200-A2-GB20-00