Paradyne 4200 manual Ent-Vcl, ENT-VCL Command Parameters

5. ATM Commands

ENT-VCL

The ENT-VCL command creates an ATM interface Virtual Channel Links (VCL) on an NT or LT.

Table 5-9. ENT-VCL Command Parameters

ENT-VCL:[tid]:aid_vcl:[ctag]::[rcv_trafdsc],[xmt_trafdsc],[ rcv_trafdscnm],[xmt_trafdscnm];

RESTRICTIONS: All parameters in this command are position-defined. If the VCL or VPI is unavailable or in use, or the resources specified by the receive or transmit traffic descriptor are not available, the command fails.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_vcl	Virtual Circuit Identifier for the Virtual Circuit. The value can be
	preceded with AID=, but this is not required. Grouping and ranging are
	allowed. Enter any of in the following formats, replacing lower-case
	parameters with the values given:
	NTVCL-vpi-vci: VCL in the NT
	LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit
	– rack: Rack number (1)
	– shelf: Shelf number (1)
	– slot: LT slot number (1)
	– circuit: DSL circuit on the LT (1− 24)
	– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0− 15)
	– vci: Virtual Channel Identifier (for LT vpi=32− 63,
	for NT vpi=32− 1023)
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
[rcv_trafdsc]1	Receive traffic descriptor profile index (1− 250).
[rcv_trafdscnm]1	Receive traffic descriptor profile name. If a local profile and network
	profile both match this name, the network profile is used.
[xmt_trafdsc]2	Transmit traffic descriptor profile index (1− 250).
[xmt_trafdscnm]2	Transmit traffic descriptor profile name. If a local profile and network
	profile both match this name, the network profile is used.

1Either rcv_trafdsc or rcv_trafdscnm must be entered, but not both.

2Either xmt_trafdsc or xmt_trafdscnm must be entered, but not both.

5-10 August 2002 4200-A2-GB20-00