Paradyne 4200 REPT-OPSTAT-T1, 4-10, 8. REPT-OPSTAT- T1 Command Parameters, Response Format, IP c

4. DS1 Facility Commands

REPT-OPSTAT-T1

The REPT-OPSTAT-T1 command reports current operational parameters for T1 (DS1) lines.

Table 4-8. REPT-OPSTAT- T1 Command Parameters

REPT-OPSTAT-T1:[tid]:aid_dsl:[ctag][;];

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_ds1	Access identifier for a a DS1 facility. The value can be preceded with
	AID=, but this is not required. Enter in the following format, replacing
	lower-case parameters with the values given:
	NTT1-circuit
	– circuit: DS1 circuit in the NT (1)
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response

sid yy-mm-dd hh:mm:ss M c COMPLD

/* REPT-OPSTAT-T1:[tid]:aid_ds1:[ctag][:] */

;

Error Response

sid yy-mm-dd hh:mm:ss M c DENY

/* REPT-OPSTAT-T1:[tid]:aid_ds1:[ctag][:] */ aid:ERRCDE=errcde

/* error description */

;

4-10 August 2002 4200-A2-GB20-00