Paradyne 4200 manual Set-Dat, 14-29, SET-DAT Command Parameters, SET-DATtidctagdate,time

14. System Commands

SET-DAT

The SET-DAT command sets the date and time in an NE.

Table 14-23. SET-DAT Command Parameters

SET-DAT:[tid]::[ctag]::date,time;

RESTRICTIONS: All parameters in this command are position-defined. Resetting the unit will also reset the date and time.

[tid]	The identification of the target NE. TID is optional and has a default
	value of null. The NE's SID code is the only other valid value.
[ctag]	The correlation tag that correlates an input command with its associated
	output response(s). It is assigned by the originator of the command. The
	value is limited to six characters, which may be an identifier or a decimal
	numeral. It is optional with a default of 0.
date	Date in the format mm-dd-yy:

Where:

–mm = 1− 12

–dd = 1− 31

–yy = 0− 99

time Time in the format hh-mm-ss:

Where:

–hh = 0− 23

–mm = 0− 59

–ss = 0− 59

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response will be sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* SET-DAT:[tid]::[ctag]::date,time */;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY

/* SET-DAT:[tid]::[ctag]::date,time */; errcde

;

4200-A2-GB20-00 August 2002 14-29