Paradyne 4200 manual Ent-Crs-Vc, 5. ENT-CRS-VC Command Parameters, ENT-CRS-VCtidntvcl,ltvclctagpst

6. Cross Connect Commands

ENT-CRS-VC

The ENT-CRS-VC command establishes a VC-level cross-connection between the NT and LT.

Table 6-5. ENT-CRS-VC Command Parameters

ENT-CRS-VC:[tid]:nt_vcl,lt_vcl:[ctag]::::[pst];

RESTRICTIONS: All parameters in this command are position-defined. The range of values for vpi and vci is determined by the number of VPI and VCI bits allocated. View the number of bits allocated with the RTRV-PROFILE-ATMACCcommand.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
nt_vcl	Virtual Channel Identifier for the Virtual Channel Link on the NT
	(network) side. Enter in the following format, replacing lower-case
	parameters with the values given:
	NTVCL-vpi-vci
	– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0− 15)
	– vci: Virtual Channel Identifier for the Virtual Channel Link (for LT
	vpi=32− 63, for NT vpi=32− 1023)
	Grouping is allowed for up to 8 AIDs. Ranging is allowed.
lt_vcl	Virtual Channel Identifier for the Virtual Channel Link on the LT (user)
	side. Enter in the following format, replacing lower-case parameters with
	the values given:
	LTVCL-rack-shelf-slot-circuit-vpi-vci: Virtual Channel in the NT
	– rack: Rack number (1)
	– shelf: Shelf number (1)
	– slot: LT slot number (1)
	– circuit: ADSL circuit on the LT (1− 24)
	– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0− 15)
	– vci: Virtual Channel Identifier (for LT vpi=32− 63,
	for NT vpi=32− 1023)
	Grouping and ranging are allowed. If these features are used, the two
	sets of AIDs must match one-to-one.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
[pst]	Desired Primary State. Valid values are:
	IS: In-Service (default)
	OOS: Out-Of-Service (OOS-MA is implied)
	If no value is specified, IS is assumed.

4200-A2-GB20-00 August 2002 6-7