Paradyne 4200 manual Rept EVT Adsl Message Parameters 1

3. ADSL Facility Commands

REPT EVT ADSL

The REPT EVT ADSL message reports current events associated with an ADSL facility on an LT.

Table 3-24. REPT EVT ADSL Message Parameters (1 of 2)

almcode atag REPT EVT ADSL aid_adsl:cond_adsl,[condeff], [ocrdat],[ocrtm],[locn],[dirn];[cond_descr];

almcde	Alarm code. Identifies the severity of the alarm. The valid value is:
	A^: Automatic message (typically reports a cleared alarm)
atag	Automatic tag indicating the numerical sequence of messages reported.
aid_adsl	Access identifier for the ADSL line(s). Enter in the following format,
	replacing lower-case parameters with the values given:
	ADSL-rack-shelf-slot-circuit
	– rack: Rack Number (1)
	– shelf: Shelf Number (1)
	– slot: LT Slot Number (1)
	– circuit: ADSL circuit on the LT (1− 24)
cond_adsl	ADSL condition. Valid values are:
	FACTERM Modem could not initialize (Near End only)
	LCD-F: Loss of Cell Delineation (fast) (Near End only)
	LOF: Loss Of Frame
	LOL: Loss Of Link (Near End only)
	LORATE: Line rate is below planned rate (Loss of Signal Quality)
	LOS: Loss Of Signal (Near End only)
	LPR: Loss of Power (Far End only)
	LOFS-L: Loss Of Frame Seconds (line)
	LOLS-L: Loss Of Link Seconds (line)
	ES-L: Errored Seconds (line)
	SES-L: Severely Errored Seconds (line)
	UAS-L: Unavailable Seconds (line)
	INCRATE-F: Increasing Rate (fast channel). There is no corresponding
	standing condition clear message.
	DECRATE-F: Decreasing Rate (fast channel). There is no
	corresponding standing condition clear message.
	LPRS-L: Loss Of Power Seconds (line) (Near End only)
	LOSS-L: Loss Of Signal Seconds (line) (Near End only)
[condeff]	The effect of the event on the condition reported. Valid values are:
	SC: Standing condition raised
	CL: Standing condition cleared
ocrdat	Date of occurrence in the format mm-dd.

3-30 August 2002 4200-A2-GB20-00