Paradyne 4200 Rtrv-Atmport, 5-13, 11. RTRV-ATMPORT Command Parameters, Response Format, IP c

5. ATM Commands

RTRV-ATMPORT

The RTRV-ATMPORT command retrieves configuration data associated with an

ATM port in the NE.

Table 5-11. RTRV-ATMPORT Command Parameters

RTRV-ATMPORT:[tid]:aid_atmport:[ctag]::::[pstf],[sstf];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_atmport	Access Identifier for an ATM port. The value can be preceded with
	AID=, but this is not required. Grouping and ranging are allowed. Enter
	any of in the following formats, replacing lower-case parameters with
	the values given:
	NTATM: ATM port in the NT
	LTATM-1-1-slot-circuit: ATM port for an LT circuit
	– slot: LT slot number (1)
	– circuit: ADSL circuit on the LT (1− 24)
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
pstf	Primary State Filter. Valid values are:
	IS: In Service
	OOS: Out Of Service
sstf	Secondary State Filter. The only valid value is LPBK (loopback).

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* RTRV-ATMPORT:[tid]:aid_atmport:[ctag]::::[pstf][sstf]

*/

;

4200-A2-GB20-00 August 2002 5-13