Paradyne 4200 manual Rtrv-Alm-Eqpt, 10-9, RTRV-ALM-EQPT Command Parameters

10. Fault Commands

RTRV-ALM-EQPT

The RTRV-ALM-EQPT command retrieves current alarms for specified equipment.

Table 10-5. RTRV-ALM-EQPT Command Parameters

RTRV-ALM-EQPT:[tid]:aid_eqpts:[ctag]::[ntfcde],,[srveff];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	The identification of the target NE. TID is optional and has a default
	value of null. The NE's SID code is the only other valid value.
aid_eqpts	Access identifier for the equipment. Each AID format can be preceded
	with AID=, but this is not required. Enter in the following format,
	replacing lower-case parameters with the values given:
	LT-rack-shelf-slot: All LT units
	LTA-rack-shelf-slot: LTA units
	SHELF-rack-shelf: shelf
	rack: Rack Number (1)
	shelf: Shelf Number (1)
	slot: LT Slot Number (1)
	Grouping is allowed. ALL may be used.
[ctag]	The correlation tag that links an input command with its associated
	output responses. It is assigned by the originator of the command. The
	value is limited to six characters, which may be an identifier or a decimal
	numeral. It is optional with a default of 0.
[ntfncde]	Notification code. Valid values are:
	CR: Critical alarm
	MJ: Major alarm
	MN: Minor alarm
	Grouping is allowed. If no value is specified, ALL is assumed.
[serveff]	Service effect. Valid values are:
	SA: Service affecting
	NSA: Not service affecting
	Grouping is allowed. If no value is specified, ALL is assumed.

4200-A2-GB20-00 August 2002 10-9