Paradyne 4200 Rtrv-Inv-Eqpt, 7. RTRV-INV-EQPT Command Parameters, RTRV-INV-EQPTtidaideqpsctag

7. Equipment Commands

RTRV-INV-EQPT

The RTRV-INV-EQPT command retrieves inventory data associated with a unit of equipment.

Table 7-7. RTRV-INV-EQPT Command Parameters

RTRV-INV-EQPT:[tid]:aid_eqps:[ctag];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_eqpts	Access identifier of an equipment unit. The value can be preceded with
	AID=, but this is not required. Enter in one of the following formats,
	replacing lower-case parameters with the values given:
	NT: All Network Termination units
	NTA Network Termination unit A
	LT-rack-shelf-slot: All LT units in a shelf-slot
	rack: Rack number (1)
	shelf: Shelf number (1)
	slot: LT slot number (1)
	ATUR-rack-shelf-slot-circuit: ADSL endpoint attached to
	LT-rack-shelf-circuit
	LTA-rack-shelf-slot: Line Termination unit A (on main card)
	LPCO-rack-shelf-slot: Low-Pass Filter-Central Office (in expansion slot)
	SHELF-rack-shelf: General shelf and chassis-level information
	Grouping is allowed. ALL may be used.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss M c COMPLD

/* RTRV-INV-EQPT:[tid]:aid_eqpt:[ctag] */

aid_eqpt:cur_eqpt,manuf,partno,[rev],[serno],clei

;

4200-A2-GB20-00 August 2002 7-9