Paradyne 4200 manual 4-15, 12. RTRV-T1 Command Parameters, RTRV-T1tidaidds1ctagpstf,sstf, IP c

4. DS1 Facility Commands

RTRV-T1

The RTRV-T1 command retrieves the configuration data associated with a DS-1 facility.

Table 4-12. RTRV-T1 Command Parameters

RTRV-T1:[tid]:aid_ds1:[ctag]::::[pstf],[sstf];

Restrictions: All parameters in this command are position-defined.

[tid]	Identification of the target NE. They default value is null. The NE SID
	code is the only other valid value.
aid_ds1	Access Identifier for the DS1 facility. The value can be preceded with
	AID=, but this is not required. Grouping and ranging are allowed. Enter
	in the following format, replacing lower-case parameters with the values
	given:
	NTT1-circuit
	– circuit: DS1 circuit on the NT (1)
[ctag]	Correlation tag (1...6 characters) that links an input command with
	associated output responses. The default is 0.
[pstf]	Primary state filter. Valid values are:
	IS: Matches IS-NR
	OOS: Out of service. Matches OOS-MA (out of service, management),
	OOS-AU (out of service, autonomous), OOS-AUMA (out of service,
	autonomous and management)
	AU: Autonomous. Matches OOS-AU, OOS-AUMA
	MA: Management. Matches OOS-MA, OOS-AUMA
	If no value is specified, this filter is ignored.
[sstf]	Secondary state filter. The value is:
	LPBK: Retrieve looped-back entities only
	If no value is specified, this filter is ignored.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

4200-A2-GB20-00 August 2002 4-15