Paradyne 4200 Stp-Lamptst, 15-13, 11. STP-LAMPTST Command Parameters, STP-LAMPTSTtidaideqptctag

15. Test Commands

STP-LAMPTST

The STP-LAMPTST command stops a lamp (LED) test on a device.

Table 15-11. STP-LAMPTST Command Parameters

STP-LAMPTST:[tid]:aid_eqpt:[ctag];

RESTRICTION: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_eqpt	Equipment access identifier. The value can be preceded with AID=, but
	this is not required. Grouping and ranging are allowed. Enter in the
	following format, replacing lower-case parameters with the values
	given:
	COM: Common equipment system identifier.
	Grouping and ranging are not allowed.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* STP-LAMPTST:[tid]:aid_eqpt:[ctag][:] */

;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY

/* STP-LAMPTST:[tid]:aid_eqpt:[ctag][:] */ aid_eqpt:ERRCDE=errcde

/* error description */

;

4200-A2-GB20-00 August 2002 15-13