Paradyne 4200 manual Dlt-Atmarpent, DLT-ATMARPENT Command Parameters

8. IP Access Commands

DLT-ATMARPENT

The command DLT-ATMARPENT deletes entries in the ATM Address Resolution Protocol table.

Table 8-1. DLT-ATMARPENT Command Parameters

DLT-ATMARPENT:[tid]:aid_ipport:[ctag]::ip_addr;

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_ipport	Access identifier of the IP port to be deleted. The value can be
	preceded with AID=, but this is not required. The valid values are:
	ATM-1: First IP-over-ATM interface in the NT
	ATM-2: Second IP-over-ATM interface in the NT
	Grouping is allowed and ALL may be used.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
ip_addr	The IP address associated with the port. Valid values are:
	ddd.ddd.ddd.ddd (where ddd is 1− 255).
	ALL may be used.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* DLT-ATMARPENT:[tid]:aid_ipport:[ctag]::ip_addr */

;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY;

/* DLT-ATMARPENT:[tid]:aid_ipport:[ctag]::ip_addr */ aid:ERRCDE=errcde

/* error description */

;

8-2 August 2002 4200-A2-GB20-00