Paradyne 4200 manual Rtrv-Eqpt, RTRV-EQPT Command Parameters, RTRV-EQPTtidaideqptsctag

7. Equipment Commands

RTRV-EQPT

The RTRV-EQPT command retrieves configuration data associated with a unit of equipment.

Table 7-5. RTRV-EQPT Command Parameters

RTRV-EQPT:[tid]:aid_eqpts:[ctag][:];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_eqpts	Access identifier of an equipment unit. The value can be preceded with
	AID=, but this is not required. Enter in one of the following formats,
	replacing lower-case parameters with the values given:
	– NT: All Network Termination units
	– NTA Network Termination unit A
	– LT-rack-shelf-slot: All LT units in a rack-shelf-slot
	– rack: Rack number (1)
	– shelf: Shelf number (1)
	– slot: LT slot number (1)
	– LTA-rack-shelf-slot: Line Termination unit A (on main card)
	– LPCO-rack-shelf-slot: Low-Pass Filter-Central Office (in
	expansion slot
	Grouping is allowed. ALL may be used.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* RTRV-EQPT:[tid]:aid_eqpts:[ctag] */

aid_eqpts:[eqpt_type],[cur_eqpt]:[eqpt_nblk]:state,[sst]

;

7-6 August 2002 4200-A2-GB20-00