Paradyne 4200 Rept-Opstat-Vcl, 9-10, 7. REPT-OPSTAT-VCL Command Parameters, Response Format, IP c

9. Performance Commands

REPT-OPSTAT-VCL

The REPT-OPSTAT-VCL command reports operational parameters for a Virtual

Channel Link (VCL) on an NT or LT.

Table 9-7. REPT-OPSTAT-VCL Command Parameters

REPT-OPSTAT-VCL:[tid]:aid_vcl:[ctag][:];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_vcl	Virtual channel identifier for the virtual circuit. The value can be
	preceded with AID=, but this is not required. Grouping and ranging are
	allowed. Enter in the following format, replacing lower-case parameters
	with the values given:
	NTVCL-vpi-vci
	LTVCL-rack-shelf-slot-circuit-vpi-vci
	Grouping and ranging are allowed.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss M c COMPLD

/* REPT-OPSTAT-VCL:[tid]:aid_vcl:[ctag][:] */ "aid_vcl:op_vcl,value"

;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY

/* REPT-OPSTAT-VCL:[tid]:aid_vcl:[ctag][:] */ "aid_VCL:ERRCDE=errcde"

/* error description */

;

9-10 August 2002 4200-A2-GB20-00