Paradyne 4200 manual Ed-Profile-Adsldnalm, 3-16, 13. ED-PROFILE-ADSLDNALM Command Parameters

3. ADSL Facility Commands

ED-PROFILE-ADSLDNALM

The ED-PROFILE-ADSLDNALM command enables you to edit ADSL alarm line configuration parameters for the downstream direction (from ATU-C to ATU-R) in an ADSL Alarm Profile. See ENT-PROFILE-ADSLALMon page 3-26for information on how to create a new ADSL alarm profile.

Table 3-13. ED-PROFILE-ADSLDNALM Command Parameters

ED-PROFILE-ADSLDNALM:[tid]:adsl_profile_id:[ctag]:::[adslpr of_nblk];

RESTRICTIONS: All parameters in this command are position-defined. After a profile is activated, its parameters cannot be edited.

[tid]	Identification of the target NE. TID is optional and has a default value of
	null. The NE's SID code is the only other valid value.
adsl_profile_id	Numeric identifier of a profile (1− 30).
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
[adslprof_nblk]	ADSL parameter block containing one or more of the following named
	parameters (separated by commas):
	LOFS-L: Loss Of Frame Seconds (line). SNMP trap and TL1
	autonomous message are sent if the number of LOFS events in a
	15-minute interval meets or exceeds the selected value (0− 900
	seconds, where 0 disables the messages). The default is 0.
	LPRS-L: Loss Of Power Seconds (line). SNMP trap and TL1
	autonomous messages are sent if the number of LPRS events in a
	15-minute interval meets or exceeds the selected value (0− 900
	seconds, where 0 disables the messages). The default is 0. (This
	statistic is not incremented when a Hotwire Model 6390 ReachDSL
	Modem is attached to the line.)
	ES-L: Errored Seconds (line). SNMP trap and TL1 autonomous
	message are sent if the number of ES events in a 15-minute interval
	meets or exceeds the selected value (0− 900 seconds, where 0 disables
	the messages). The default is 0.
	SES-L: Severely Errored Seconds (line). SNMP trap and TL1
	autonomous message are sent if the number of SES events in a
	15-minute interval meets or exceeds the selected value (0− 900
	seconds, where 0 disables the messages). The default is 0.
	UAS-L: Unavailable Seconds (line). SNMP trap and TL1 autonomous
	message are sent if the number of UAS events in a 15-minute interval
	meets or exceeds the selected value (0− 900 seconds, where 0 disables
	the messages). The default is 0.
	INCRATE-F: Increasing Rate (fast channel). SNMP rate change trap
	and TL1 autonomous message are sent if the current rate is ≥ the
	previous rate plus this threshold (0-2176 kbps in 32 kbps increments,
	where 0 disables the messages). The default is 0.
	DECRATE-F: Decreasing Rate (fast channel). SNMP rate change trap
	and TL1 autonomous message are sent if the current rate is ≤ the
	previous rate minus this threshold (0-2176 kbps in 32 kbps increments,
	where 0 disables the messages). The default is 0.
	If not specified, the values of these parameters remain unchanged.

3-16 August 2002 4200-A2-GB20-00