Paradyne 4200 manual 3-22, 17. ED-PROFILE-ADSLUPALM Command Parameters 2 of, Response Format, IP c

3. ADSL Facility Commands

Table 3-17. ED-PROFILE-ADSLUPALM Command Parameters (2 of 2)

ED-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag]:::[adslpr of_nblk];

[adslprof_nblk]

(continued)

DECRATE-F: Decreasing Rate (fast channel). SNMP rate change trap and TL1 autonomous message are sent if the current rate is ≤ the previous rate minus this threshold (0-2176 kbps in 32 kbps increments, where 0 disables the messages). The default is 0.

INITFAIL: Initialization Failure. Enables or disables InitFailureTrap messages specified in RFC 2662.

–Y: Enable Initialization Failure Trap messages only.

–N: Disable Initialization Failure Trap messages only (Default).

If not specified, the values of these parameters remain unchanged.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* ED-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag]:::

[adslprof_nblk] */

;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY

/* ED-PROFILE-ADSLUPALM:[tid]:adsl_profile_id:[ctag]::: [adslprof_nblk] */

errcde

;

3-22 August 2002 4200-A2-GB20-00