Paradyne 4200 manual REPT-OPSTAT-ADSLUP Response Parameters, Explanation

9. Performance Commands

Table 9-6.	REPT-OPSTAT-ADSLUP Response Parameters
Parameter		Explanation
tid		Target NE identification
yy-mm-dd		Year, month, and day
hh:mm:ss		Hour, minute, and second
M		Message generated in response to an input command
c		If provided, ctag; otherwise 0
COMPLD		Completed
DENY		Input command is denied
/* */		Enclosed are human readable comments – unspecified format
errcde		Error code (see Appendix A, Error Codes)
aid_adsl		As described for command parameters (see Table 9-5,
		REPT-OPSTAT-ADSLUP Command Parameters).
op_adsl		ADSL operational parameter. Values are:
		ATEN: Signal attenuation (0 − 60 dB)
		CELLSF: Rolling count of cells transmitted upstream on Fast channel
		(received by ATU-C)
		CELLSDSCF: Rolling count of cells received on Fast channel and
		discarded for any reason
		CURFBR: Current Fast channel bit rate (32 − 2176 QOSCLASSF:
		Quality of Service for the ADSL Fast channel. The supported option is
		UBR (Unspecified bit rate). UBR is the default.
		EWL: Equivalent Working Length. Specifies the length of the DSL line.
		This value is used to limit transmit rates and maximum power settings
		according to local spectrum management guidelines. EWL is usually
		specified by the carrier. The default is 10 kft. The values supported are:
		– 8.5 to 14.5 kft in .5 kft increments
		– >14.5 kft
		POTSLVL: POTS Level. Specifies the voltage used to detect the
		presence of Plain Old Telephone Service (POTS) on the DSL line. The
		dafault is 3 volts. The values supported are:
		– 0 to 74 volts, in 1-volt increments (setting to 74 volts disables
		POTS detection)
		– Disable (disables POTS detection)
		NMR: Noise margin (0 − 31 dB)
		PWR: Transmitted signal power n (0− 20 dB)
		RELCAP: Relative capacity operation. Configured bit rate as a
		percentage of the cuurent bit rate (0 − 100)
		UNKCELLSF: Rolling count of received cells discarded during cell
		header validation with unrecognized VPI/VCI values
value		Value of parameter specified by op_adsl

9-8 August 2002 4200-A2-GB20-00