Paradyne 4200 Set-Sid, 14-35, 27. SET-SID Command Parameters, SET-SIDtidctagsid, Response Format

14. System Commands

SET-SID

The SET-SID command sets the system identifier (SID) of a network element.

Table 14-27. SET-SID Command Parameters

SET-SID:[tid]::[ctag]::sid;

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	The identification of the target NE. TID is optional and has a default
	value of null. The NE's SID code is the only other valid value.
[ctag]	The correlation tag that correlates an input command with its associated
	output response(s). It is assigned by the originator of the command. The
	value is limited to six characters, which may be an identifier or a decimal
	numeral. It is optional with a default of 0.
sid	System identifier. A text string of up to 16 characters that uniquely
	identifies the NE.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response will be sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* SET-SID:[tid]::[ctag]::sid */

;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY

/* SET-SID:[tid]::[ctag]::sid */; errcde

;

4200-A2-GB20-00 August 2002 14-35