Paradyne 4200 manual Rept-Opstat-Adslcom, REPT-OPSTAT-ADSLCOM Command Parameters

9. Performance Commands

REPT-OPSTAT-ADSLCOM

The REPT-OPSTAT-ADSLCOM command reports current operational parameters of ADSL lines that are common for both upstream and downstream directions.

Table 9-1. REPT-OPSTAT-ADSLCOM Command Parameters

REPT-OPSTAT-ADSLCOM:[tid]:aid_adsl:[ctag][:];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_adsl	Access identifier for ADSL lines. The value can be preceded with AID=,
	but this is not required. Grouping and ranging are allowed. Enter in the
	following format, replacing lower-case parameters with the values
	given:
	ADSL-rack-shelf-slot-circuit rack:
	– rack: Rack number (1)
	– shelf: Shelf number (1)
	– slot: LT slot number (1)
	– circuit: ADSL circuit on the LT (1− 24)
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* REPT-OPSTAT-ADSLCOM:[tid]:aid_adsl:[ctag][:] */

"aid_adsl:op_adslcom,value"

;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY

/* REPT-OPSTAT-ADSLCOM:[tid]:aid_adsl:[ctag][:] */ aid:ERRCDE=errcde

;

9-2 August 2002 4200-A2-GB20-00