Paradyne 4200 Dlt-Ipport, 3. DLT-IPPORT Command Parameters, DLT-IPPORTtidaidipportctag, IP c

8. IP Access Commands

DLT-IPPORT

The command DLT-IPPORT deletes an Internet Protocol port (or interface) in the NE. All entries in the ATM Address Resolution Protocol table for a IP port must be deleted (DLT-ATMARPENTon page 8-2) before the port can be deleted.

Table 8-3. DLT-IPPORT Command Parameters

DLT-IPPORT:[tid]:aid_ipport:[ctag][;];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_ipport	Access identifier of the IP port to be entered. The value can be
	preceded with AID=, but this is not required. The valid values are:
	ATM-1: First IP-over-ATM interface in the NT
	ATM-2: Second IP-over-ATM interface in the NT
	ETH-1: First Ethernet interface in the NT
	Grouping is allowed and ALL may be used.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* DLT-IPPORT:[tid]:aid_ipport:[ctag][:]: */

;

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY;

/* DLT-IPPORT:[tid]:aid_ipport:[ctag][:]: */ aid:ERRCDE=errcde

/* error description */

;

8-4 August 2002 4200-A2-GB20-00