Paradyne 4200 manual 14-32, 25. SET-NE-ALL Command Parameters 2 of, SET-NE-ALLtidaidcomctagnenblk

Models: 4200

1 382
Download 382 pages 39.36 Kb
Page 294
Image 294
Table 14-25. SET-NE-ALL Command Parameters (2 of 2)

14. System Commands

Table 14-25. SET-NE-ALL Command Parameters (2 of 2)

SET-NE-ALL:[tid]:[aid_com]:[ctag]:::ne_nblk;

ne_nblk

RMTSYSLOG: Remote syslog. Enables or disables syslog messages to

 

a remote daemon. The default is Disabled.

SYSLOGIPADDR: Syslog server IP address. Specifies the IP address of a remote syslog server if RMTSYSLOG is enabled. Valid values are:

ddd.ddd.ddd.ddd: IP address (ddd = 0255)

NONE: No server is specified

SYSLOGPORT: Syslog UDP port. Specifies the destination UDP port number used to send syslog messages to a remote syslog server if RMTSYSLOG is enabled (065535).

SYSLOGSEVTHLD: Syslog severity threshold. Specifies the minimum severity level of messages logged to the syslog. Valid values are:

EMERG: Emergency. System is unusable.

ALERT: Action must be taken immediately (unused).

CRITICAL: Critical and major alarm conditions.

ERROR: Minor alarms and autonomous message classification alarms.

WARNING: Warning conditions (unused).

NOTICE: Normal but significant conditions (unused).

INFO: Informational messages related to operational task status such as download successful, configuration change notification, and test start/stop.

SYSLOGRTLMT: Syslog rate limiting. Enables or disables syslog rate limiting. Valid values are:

ENABLED: The same syslog message will not be relogged within a 5-minute period.

DISABLED: Rate limiting of syslog messages will not be performed.

SPECMGMT: Spectrum management. Enables or disabled spectrum management support. When enabled, the maximum transmit speeds and maximum transmit power are limited to meet local spectrum management guidelines. Valid values are:

ENABLED: Spectrum management guidelines are enforced on the NE.

DISABLED: Spectrum management guidelines are not enforced on the NE.

TSTTMOUT: Test timeout. Specifies the amount of time a test will be allowed to run before automatic termination (099 minutes, where 0 disables automatic timeout)

14-32

August 2002

4200-A2-GB20-00

Page 294
Image 294
Paradyne 4200 manual 14-32, 25. SET-NE-ALL Command Parameters 2 of, SET-NE-ALLtidaidcomctagnenblk