Paradyne 4200 manual Rtrv-Adsl, RTRV-ADSL Command Parameters, RTRV-ADSLtidaidadslctagpstf,sstf

3. ADSL Facility Commands

RTRV-ADSL

The RTRV-ADSL command retrieves operational parameters configured for ADSL lines.

Table 3-25. RTRV-ADSL Command Parameters

RTRV-ADSL:[tid]:aid_adsl:[ctag]::::[pstf],[sstf];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_adsl	Access identifier for an ADSL line. The value can be preceded with
	AID=, but this is not required. Grouping and ranging are allowed. Enter
	in the following format, replacing lower-case parameters with the values
	given:
	ADSL-rack-shelf-slot-circuit
	rack: Rack number (1)
	shelf: Shelf number (1)
	slot: LT slot number (1)
	circuit: ADSL circuit on the LT (1− 24)
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
[pstf]	Primary state filter. Valid values are:
	IS: Retrieve In-Service entities only
	OOS: Retrieve Out-Of-Service entities only
	Grouping is allowed. If no value is specified, this filter is ignored.
[sstf]	Secondary state filter. This filter is ignored.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* RTRV-ADSL:[tid]:aid_adsl:[ctag]::::[pstf] */ "aid_adsl:adsl_nblk:state"

;

3-32 August 2002 4200-A2-GB20-00