Paradyne 4200 Dlt-Vcl, 3. DLT-VCL Command Parameters, DLT-VCLtidaidvclctag, Response Format, IP c

5. ATM Commands

DLT-VCL

The DLT-VCL command deletes selected ATM interface Virtual Channel Links (VCL) that are not in use.

Table 5-3. DLT-VCL Command Parameters

DLT-VCL:[tid]:aid_vcl:[ctag][:];

RESTRICTIONS: All parameters in this command are position-defined. If the VCL is cross-connected, the deletion fails.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_vcl	Virtual Circuit Identifier for the Virtual Circuit. The value can be
	preceded with AID=, but this is not required. Grouping and ranging are
	allowed. Enter any of in the following formats, replacing lower-case
	parameters with the values given:
	NTVCL-vpi-vci: VCL in the NT
	LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit
	– rack: Rack number (1)
	– shelf: Shelf number (1)
	– slot: LT slot number (1)
	– circuit: DSL circuit on the LT (1− 4)
	– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0− 15)
	– vci Virtual Channel Identifier (for LT vpi=32− 63,
	for NT vpi=32− 1023)
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* DLT-VCL:[tid]:aid_vcl:[ctag][:] */

;

5-4 August 2002 4200-A2-GB20-00