Paradyne 4200 Rtrv-Vcl, 5-21, 17. RTRV-VCL Command Parameters, RTRV-VCLtidaidvcictagpstf,sstf

5. ATM Commands

RTRV-VCL

The RTRV-VCL command retrieves configuration data associated with an ATM virtual channel link.

Table 5-17. RTRV-VCL Command Parameters

RTRV-VCL:[tid]:aid_vci:[ctag]::::[pstf],[sstf];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_vci	Virtual Circuit Identifier for the Virtual Circuit. The value can be
	preceded with AID=, but this is not required. Grouping and ranging are
	allowed. Enter any of in the following formats, replacing lower-case
	parameters with the values given:
	NTVCL-vpi-vci: VCL in the NT
	LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit
	– rack: Rack number (1)
	– shelf: Shelf number (1)
	– slot: LT slot number (1)
	– circuit: DSL circuit on the LT (1− 24)
	– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0− 15)
	– vci Virtual Channel Identifier (for LT vpi=32− 63,
	for NT vpi=32− 1023)
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
pstf	Primary State Filter. If no value is specified, this filter is ignored. Valid
	values are:
	IS: In Service
	OOS: Out Of Service
sstf	Secondary State Filter. The only valid value is LPBK (loopback).

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

4200-A2-GB20-00 August 2002 5-21