Paradyne 4200 manual 10-25, 15. RTRV-ATTR-T1 Command Parameters

10. Fault Commands

RTRV-ATTR-T1

The RTRV-ATTR-T1 command retrieves current attributes of activities related to the DS1 facility.

Table 10-15. RTRV-ATTR-T1 Command Parameters

RTRV-ATTR-T1:[tid]:[aidall_t1]:[ctag]::[ntfcde],[cond_ds1], [locn],[dirn];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	The identification of the target NE. TID is optional and has a default
	value of null. The NE's SID code is the only other valid value.
[aidall_t1]	Access Identifier for all T1 (DS1) facilities. The value is T1.
[ctag]	The correlation tag that correlates an input command with its associated
	output response(s). It is assigned by the originator of the command. The
	value is limited to six characters, which may be an identifier or a decimal
	numeral. It is optional with a default of 0.
[ntfncde]	Notification code. Valid values are:
	CR: Critical alarm
	MJ: Major alarm
	MN: Minor alarm
	NA: Not alarmed (reported via REPORT EVENT)
	Grouping is allowed. If no value is specified, ALL is assumed.
[cond_ds1]	DS1 facility condition. Valid values are:
	ACTLPBK: Facility placed in loopback (Default = NA)
	AIS: Alarm Indication Signal
	LCD: Loss of ATM Cell Delineation
	LOF: Loss of Framing (Default = MN)
	LOS: Loss of Signal/Clock (Default = MI)
	RAI: Remote Alarm Indication (Default = MN)
	If no value is specified, ALL is assumed.
[locn]	Location of the condition. Valid value is NEND (Near End).
	Only applicable to conditions supporting location.
[dirn]	Direction of the signal. Valid value is:
	RCV: Receive
	If no value is specified, ALL is assumed.

4200-A2-GB20-00 August 2002 10-25