Paradyne 4200 manual Rept ALM Adsl Message Parameters 1

3. ADSL Facility Commands

REPT ALM ADSL

The REPT ALM ADSL message reports current alarms associated with an ADSL facility on an LT.

Table 3-23. REPT ALM ADSL Message Parameters (1 of 2)

almcode atag REPT ALM ADSL aid_adsl:ntfcde,cond_adsl, srveff,[ocrdat],[ocrtm],[locn], [dirn];[cond_descr];

almcde	Alarm code. Identifies the severity of the alarm. Values are:
	*C: Critical alarm
	**: Major alarm
	*^: Minor alarm
	A^: Automatic message (typically reports a cleared alarm)
atag	Automatic tag indicating the numerical sequence of messages reported.
aid_adsl	Access identifier for the ADSL line(s). Enter in the following format,
	replacing lower-case parameters with the values given:
	ADSL-rack-shelf-slot-circuit
	– rack: Rack Number (1)
	– shelf: Shelf Number (1)
	– slot: LT Slot Number (1)
	– circuit: ADSL circuit on the LT (1− 24)
	Grouping and ranging are allowed.
ntfncde	Notification code. Valid values are:
	CR: Critical alarm
	MJ: Major alarm
	MN: Minor alarm
	CL: Cleared alarm
cond_adsl	ADSL condition. Valid values are:
	FACTERM Modem could not initialize (Near End only)
	LCD-F: Loss of Cell Delineation (fast) (Near End only)
	LOF: Loss of Frame
	LOL: Loss of Link
	LORATE: Line rate is below planned rate (Loss of Signal Quality)
	LOS: Loss of Signal (Near End only)
	LPR: Loss of Power (Far End only)
[serveff]	Service effect. Valid values are:
	SA: Service affecting
	NSA: Not service affecting
ocrdat	Date of occurrence in the format mm-dd.
ocrtm	Time of occurrence in the format hh-mm.

3-28 August 2002 4200-A2-GB20-00