Paradyne 4200 manual 6. REPT ALM T1 Response Parameters

4. DS1 Facility Commands

REPT ALM T1

The REPT ALM T1 message reports current T1 (DS1) facility alarms from the NE.

Table 4-6. REPT ALM T1 Response Parameters

almcode atag REPT ALM T1 "aid_ds1:ntfncde,cond_ds1, serveff,[ocrdat],[ocrtm],[locn],[dirn]:[cond_descr]";

almcde	Alarm code. Identifies the severity of the alarm. Values are:
	*C: Critical alarm
	**: Major alarm
	*^: Minor alarm
	A^: Automatic message (typically used to report a cleared alarm)
atag	Automatic tag that indicates the numerical sequence of messages
	reported.
aid_ds1	Access identifier for an environment. Values are:
	NTT1-circuit
	– circuit: DS1 circuit in the NT (1)
ntfncde	Notification code. Values are:
	CR: Critical alarm
	MJ: Major alarm
	MN: Minor alarm
	CL: Cleared alarm
cond_ds1	DS1 facility condition. Values are:
	ACTLPBK: Facility placed in loopback
	AIS: Alarm indication signal
	LCD: Loss of ATM cell delineation
	LOF: Loss of framing
	LOS: Loss of signal/clock
	RAI: Remote alarm indication
serveff	Service effect. Values are:
	SA: Service affecting
	NSA: Not service affecting
[ocrdat]	Date of occurrence in the format: mm-dd (month and day)
[ocrtm]	Time of occurrence in the format: hh-mm (hour 0− 23 and minute 0− 59)
[locn]	Location of condition. The value is NEND (Near End).
[dirn]	Direction of condition. Values are:
	RCV: Receive
	TRMT: Transmit (for ACTLPBK)
[cond_descr]	Description of alarm condition (40 characters maximum).

4-8 August 2002 4200-A2-GB20-00