Paradyne 4200 manual 10-19, 11. RTRV-ATTR-ALL Command Parameters 2 of, Response Format, IP c

10. Fault Commands

Table 10-11. RTRV-ATTR-ALL Command Parameters (2 of 2)

RTRV-ATTR-ALL:[tid]:aid_all:[ctag]::[ntfcde],[cond_all], [locn],[dirn];

[cond_all]	DECRATE-F: Decreasing Rate (Fast channel). There is no
(continued)	corresponding standing condition clear message.
	LPRS-L: Loss Of Power Seconds (Line) (far-end only)
	LOSS-L: Loss of Signal Seconds (Line) (near-end only)
	LOS: Loss Of Signal/clock
	LPR: Loss Of Power
	LORATE: Line rate is below planned rate (Loss of Signal Quality)
	PROGVER: Failed to load or find requested software
	RAI: Remote Alarm Indication
	RMTDLFAIL: Failed to download software
	SWROLLBACK: Software version rolled back
	Grouping is allowed. If no value is specified, ALL is assumed.
[locn]	Location of the condition. Valid values are:
	NEND: Near End
	FEND: Far End
	Only applicable to conditions supporting location. If no value is
	specified, ALL is assumed.
[dirn]	Direction of the condition. Valid values (for conditions supporting
	direction):
	RCV: Receive
	TRMT: Transmit
	If no value is specified, ALL is assumed.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response will be sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* RTRV-ATTR-ALL:[tid]:aid_all:[ctag]::[ntfncde],

[cond_all] */ "aid,aid_type:ntfncde,cond,[locn],[dirn]"

;

4200-A2-GB20-00 August 2002 10-19