Paradyne 4200 manual 8-15, 12. REPT-OPSTAT-IPPORT Response Parameters, Explanation

8. IP Access Commands

Table 8-12. REPT-OPSTAT-IPPORT Response Parameters

Parameter	Explanation
tid	Target NE identification
yy-mm-dd	Year, month, and day
hh:mm:ss	Hour, minute, and second
M	Message generated in response to an input command
c	If provided, ctag; otherwise 0
COMPLD	Completed
DENY	Input command is denied
/* */	Enclosed are human readable comments – unspecified format
errcde	Error code (see Appendix A, Error Codes)
aid_ipport	Access identifier of the IP port to be entered. The value can be
	preceded with AID=, but this is not required. The valid values are:
	ATM-1: First IP-over-ATM interface in the NT
	ATM-2: Second IP-over-ATM interface in the NT
	ETH-1: First Ethernet interface in the NT
	Grouping and ranging are allowed.
[op_ipport]	IP port operational parameters. Valid values are:
	CURRATE: Displays the auto-sensed rate of operation of the Ethernet
	port or the current bandwidth associated with the ATM VCs in bps. The
	following rates are supported:
	– 0: The current bandwidth associated with the ATM VCs for the
	entry is 0 or the Ethernet port is disconnected or disabled. The
	bandwidth associated with UBR connections is 0 bps.
	– 10000000: The current auto-sensed rate on the Ethernet port is
	10 Mbps.
	– 100000000: The current auto-sensed rate on the Ethernet port is
	100 Mbps.
	CURDX: Displays the current line duplex mode. The following values
	are supported:
	– 2DX: The current auto-sensed mode is half-duplex (2-wire)
	operation (ETH-1 only).
	– 4DX: The current auto-sensed mode is full duplex (4-wire)
	operation (ETH-1, ATM-1, ATM-2).
	– NONE: The line is disconnected (ETH-1 only).
value	The value of the parameter as specified by op_ipport.

4200-A2-GB20-00 August 2002 8-15