Paradyne 4200 Ed-Eqpt, 1. ED-EQPT Command Parameters, ED-EQPTtidaideqptsctageqptnblkpst, IP c

7. Equipment Commands

ED-EQPT

The ED-EQPT command edits configuration data associated with equipment supported by the system.

Table 7-1. ED-EQPT Command Parameters

ED-EQPT:[tid]:aid_eqpts:[ctag]::[eqpt_nblk]:[pst];

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_eqpts	Access identifier of an equipment unit. The value can be preceded with
	AID=, but this is not required. Enter in one of the following formats,
	replacing lower-case parameters with the values given:
	LT-rack-shelf-slot
	LTA (Line Termination Unit A)-rack-shelf-slot
	– rack: Rack number (1)
	– shelf: Shelf number (1)
	– slot: LT slot number (1)
	Grouping and ranging are allowed.
[ctag]	Correlation tag (1− 6 characters) that links an input command with
	associated output responses. The default is 0.
[eqpt_nblk]	Named parameter block for equipment. Consists of the following
	parameter name followed by an equal sign and a valid value:
	– SWVER: Version of software that is configured (1− 32 characters).
	Input is case-sensitive. If not specified, the value of this
	parameter remains unchanged. The system resets whenever the
	software version is changed.
[pst]	Desired Primary State (LT or ACU only). Valid value is IS (In-Service). If
	not specified, the value of this parameter remains unchanged.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* ED-EQPT:[tid]:aid_eqpts:[ctag]::[eqpt_nblk]:[pst] */

;

7-2 August 2002 4200-A2-GB20-00