Paradyne 4200 3-33, RTRV-ADSLtidaidadslctagpstf */ aidERRCDE=errcde error description, Parameter

3. ADSL Facility Commands

Error Response:

sid yy-mm-dd hh:mm:ss M c DENY

/* RTRV-ADSL:[tid]:aid_adsl:[ctag]::::[pstf] */ aid:ERRCDE=errcde

/* error description */

;

Table 3-26. RTRV-ADSL Response Parameters (1 of 2)

Parameter	Explanation
tid	Target NE identification
yy-mm-dd	Year, month, and day
hh:mm:ss	Hour, minute, and second
M	Message generated in response to an input command
c	If provided, ctag; otherwise 0
COMPLD	Completed
DENY	Input command is denied
/* */	Enclosed are human readable comments – unspecified format
aid_adsl	As described for command parameters (see Table 3-25,RTRV-ADSL
	Command Parameters), except that ALL is not used
adsl_nblk	Named parameter block for ADSL line. The block consists of one or
	more of the following parameters, in any order separated by commas,
	each followed by an equal sign and a valid value.
	ADSLPROF: ADSL Line Profile (1− 30)
	ADSLPROFNM: ADSL Line Profile name
	ATMACCPROFF: ATM access profile index for the ADSL fast channel
	(numeric index of 2)
	PORTID: Port identifier (1− 32 characters). Indicates the user to whom
	the port is assigned.
	QOSCLASSF: Quality of Service for the ADSL Fast channel. Valid value
	is UBR (Unspecified bit rate).
	EWL: Equivalent Working Length. Specifies the length of the DSL line.
	This value is used to limit transmit rates and maximum power settings
	according to local spectrum management guidelines. EWL is usually
	specified by the carrier. The values supported are:
	– 8.5 to 14.5 kft in .5 kft increments
	– >14.5 kft
	POTSLVL: POTS Level. Specifies the voltage used to detect the
	presence of Plain Old Telephone Service (POTS) on the DSL line. The
	values supported are:
	– 0 to 74 volts, in 1-volt increments (setting to 74 volts disables
	POTS detection)
	– Disable (disables POTS detection)

4200-A2-GB20-00 August 2002 3-33