Paradyne 4200 Ent-Profile-Adsl, 3-24, 19. ENT-PROFILE-ADSL Command Parameters, profilename, IP c

3. ADSL Facility Commands

ENT-PROFILE-ADSL

The ENT-PROFILE-ADSL command allocates a new ADSL line configuration profile. A new ADSL profile is created using the following steps:

1.Allocate a new profile with ENT-PROFILE-ADSL.

2.Configure downstream transmission parameters with ED-PROFILE-ADSLDN.

3.Configure upstream transmission parameters with ED-PROFILE-ADSLUP.

4.Activate the profile with ACT-PROFILE-ADSL.

5.Apply the profile to a port with ED-ADSL.

Table 3-19. ENT-PROFILE-ADSL Command Parameters

ENT-PROFILE-ADSL:[tid]:[adsl_profile_id]:[ctag]::profile_na me,,[latency];

RESTRICTIONS: Valid only for profiles with LOCAL scope. All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
adsl_profile_id	ADSL profile index (1− 30). The profile must not already be in use.
	Profile 1 (a predefined profile shipped with the system) is the default
	and is always active. If no profile is entered, the next available profile
	index will be assigned. If an index is entered, it must be the next
	available index.
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
profile_name	Name (1− 32 characters) that uniquely identifies the profile
latency	Latency of the ADSL line. Only single latency is supported upstream
	and downstream. The valid value is FAST (only ADSL FAST
	supported).

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Normal Response:

sid yy-mm-dd hh:mm:ss

Mc COMPLD

/* ENT-PROFILE-ADSL:[tid]:adsl_profile_id:[ctag]::

profile_name */

;

3-24 August 2002 4200-A2-GB20-00