Paradyne 4200 manual Ent-Ipport, 8-11, 9. ENT-IPPORT Command Parameters

8. IP Access Commands

ENT-IPPORT

The command ENT-IPPORT configures an Internet Protocol port (or interface) in the NE.

Table 8-9. ENT-IPPORT Command Parameters

ENT-IPPORT:[tid]:aid_ipport:[ctag]::cfg_mode:ipport_nblk;

RESTRICTIONS: All parameters in this command are position-defined.

[tid]	Identification of the target NE. The default value is null. The NE SID
	code is the only other valid value.
aid_ipport	Access identifier of the IP port to be entered. The value can be
	preceded with AID=, but this is not required. The valid values are:
	ATM-1: First IP-over-ATM interface in the NT
	ATM-2: Second IP-over-ATM interface in the NT
	ETH-1: First Ethernet interface in the NT
[ctag]	Correlation tag (6 characters maximum) that links an input command
	with associated output responses. The default is 0.
cfg_mode	Configuration mode for the IP port. Valid values are:
	MANUAL: Port parameters are configured by the operator.
	BOOTP: Port parameters are configured using the BOOTP or DHCP
	protocol (default).
ipport_nblk	Named parameter block for IP Port. The block consists of one or more
	of the following parameters, in any order separated by commas, each
	followed by an equal sign and a valid value.
	IPADDR: IP address associated with the port. Required if
	cfg_mode=MANUAL. Auto-configured if cfg_mode=BOOTP. Valid
	values are:
	– ddd.ddd.ddd.ddd (where ddd is a number 1− 255).
	NETMASK: IP address network mask. Used if cfg_mode=MANUAL.
	Auto-configured if cfg_mode=BOOTP. Valid values are:
	– ddd.ddd.ddd.ddd (where ddd is a number 1− 255). All values are
	valid for ETH-1. For ATM-1 and ATM-2, the value must be
	255.255.255.255.
	GATEWAY: IP address of the default IP router (gateway) for this IP
	interface. Valid values are:
	– ddd.ddd.ddd.ddd (where ddd is a number 1− 255) for ETH-1 only.
	– NONE: No gateway
	PHYADDR: Physical address associated with the port. Used by BOOTP
	on ETH-1. Valid values are:
	– xx-xx-xx-xx-xx-xx-xx-xx where each x is a hexadecimal digit
	(0− F). This must be the MAC address originally assigned to the
	unit if aid_port is ETH-1.
[pst]	Desired primary state. Valid values are:
	IS: In Service (default)
	OOS: Out Of Service (OOS-MA is implied)
	If no value is specified, this parameter remains unchanged.

4200-A2-GB20-00 August 2002 8-11