Maxon Telecom WL7 Daily Pre-Operation & Operation Checklist, Pre-Operation Checks

DAILY PRE-OPERATION & OPERATION CHECKLIST

NOTE: PRE-OPERATION and OPERATION CHECKS should be performed by the Lift Operator.

PRE-OPERATION CHECKS

Park vehicle on level ground, shift vehicle transmission to PARK, and set vehicle emergency brake before doing the following checks..

Visually check Lift for bent or broken parts, or for hydraulic fluid around base. Have hydraulic fluid leaks, and the fluid level in reservoir, checked by a qualified technician.

Check for hydraulic fluid leaking from cylinders. Lift may be operated if cylinders are “weeping” a light film of hydraulic fluid. If hydraulic fluid drips from either cylinder, have it checked by a qualified technician.

Check that all Decals are in place, undamaged, and legible (see DECALS pages).

Check that all anti-slip and safety striping is in place (see ANTI-SLIP & SAFETY STRIPING pages).

If the Lift is dirty, clean it.

Make sure the ON/OFF switch on the Pump Cover is turned ON. If indicator on the switch is illumi- nated, Lift has power to operate.

NOTE: If any of the PRE-OPERATION CHECKS have incorrect indications, do not operate the Lift until repairs are performed by a qualified technician.

OPERATION CHECKS

Operate the Lift through one full cycle to do the following checks.

Use Lift operating instructions in this manual to UNFOLD, LOWER, RAISE, and FOLD platform.

Make sure the Lift responds properly to hand control switches.

Listen for unusual noises while the Lift oper- ates.

Watch for uneven movement of the Lift arms, platform, and inboard and outboard rollstops.

NOTE: If any of the OPERATION CHECKS have incorrect indications, discontinue operat- ing Lift until repairs are performed by a qualified technician.

PATENTS PENDING 6